Cannon TRADITIONAL 60 Service Manual download pdf (Page 32)

Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the

adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data

badge which is fitted on the back panel.

This appl

iance is not designed to be connected to a combustion products evacuation device. It must be

installed and connected in accordance with current installation regulations. particular attention should be given

to the relevant requirements regarding ventilation.

MODEL NUMBERS C60DPF, C60DTF

Category II2H3+ (GB)

These models are set to burn NATURAL GAS (G20) at 20 mbar but can be converted for use on BUTANE (G30)

at 28-30mbar or PROPANE (G31) at 37mbar with the use of the LPG conversion kit that can be obtained

free of

charge, if you contact our Genuine Parts and Accessories department (see Key Contacts, back page).

GAS SAFETY (INSTALLATION & USE) REGULATIONS

It is the law that all gas appliances are installed by competent persons in accordance with the current edition of

the above regulations. It is in your interest and that of safety to ensure compliance with the law. In the UK,

CORGI registered

installers work to safe standards of practice. The cooker must also be installed in accordance

with BS 6172. Failure to install the cooker correctly could invalidate the warranty liability claims and could lead

to prosecution.

LOCATION

The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath

or shower. The cooker must not be installed in a bed-sitting room of less than 20m

When adjusted for use on Butane (G30) or Propane (G31), the cooker must not be installed in a room or internal

space below ground level, e.g. in a basement.

PROVISION FOR VENTILATION

The room containing the cooker should have an air supply in accordance with BS 5440: Part 2.

The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the

room has a vo

lume between 5 and 10m

, it will require an air vent of 50cm

effective area unless it has a door

which opens directly to outside. If the room has a volume of less than 5m

, it will require an air vent of 100cm

effective area. If there are other fuel burning appliances in the same room, BS 5440: Part 2 should be consulted

to determine air vent requirements.

INSTALLATION INSTRUCTIONS

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Cannon TRADITIONAL 60 Service Manual Page 32