Cannon Professional User Manual download pdf (Page 27)

Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the

adjustment conditions are compatible. The adjustment conditions for this appliance are stated on the data

badge which is fitted on the back panel.

This

appliance is not designed to be connected to a combustion products evacuation device. It must be

installed and connected in accordance with current installation regulations. particular attention should be given

to the relevant requirements regarding ventilation.

MODEL NUMBERS 10750G, 10755G, 10756G

Category I2H (GB)

This model is set to burn NATURAL GAS (G20) at 20 mbar.

GAS SAFETY (INSTALLATION & USE) REGULATIONS

It is the law that all gas appliances are installed by competent persons in accordance with the current edition of

the above regulations. It is in your interest and that of safety to ensure compliance with the law.

In the UK, CORGI registered installers work to

safe standards of practice.

The cooker must also be installed in accordance with BS 6172.

Failure to install the cooker correctly could invalidate the warranty liability claims and could lead to prosecution.

LOCATION

The cooker may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath

or shower. The cooker must not be installed in a bed-sitting room of less than 20m

PROVISION FOR VENTILATION

The room containing the cooker should have an air supply in accordance with BS 5440: Part 2.

The room must have an opening window or equivalent; some rooms may also require a permanent vent. If the

room has a volume between 5

and 10m

, it will require an air vent of 50cm

effective area unless it has a door

which opens directly to outside. If the room has a volume of less than 5m

, it will require an air vent of 100cm

effective area. If there are other fuel burning appliances in the same room, BS 5440: Part 2 should be consulted

to determine air vent requirements.

INSTALLATION INSTRUCTIONS

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

No comments

Cannon Professional User Manual Page 27