CannonFITZROY INBUILTUSER INSTRUCTIONSINSTALLATION INSTRUCTIONSSERVICE INSTRUCTIONSGmk10025AS4553:2008This heater is approved for use with Please leav
191012Installation tipsFor installation into a masonry or brick fireplace WITH a flue connection, refer figure 7. For installation WITHOUT refer figur
1811Installation WITHOUT a flue connected89 2827 200mm min.Flue cowl. Approved to AG604100mmFasten and seal baffle plate to top of chimney
171225Gas control24 Plastic CapPressure adjustment (Burner ‘Full on’)Burner adjustment(Burner ‘Low flame’)Pressure test pointwith captive screwImpo
1316DO NOT SEAL WITH SILICONIf using a spacer to compensate for lack of chimney depth ensure the tape is placed on the outer rim of
1. The burner is contained within the burner chamber. Refer figure 15.2. Carefully unpack the log set. Logs are numbered as follows:#1 - Left front lo
NOTES2ContentsContents 2Warranty 3? DistributorSafety warnings 5-6? What to do if you smell gas? Warnings? StandardsUser instructions 7-8? Operati
26NOTESWarrantyDon’t risk your appliance warrantyOnly a licensed person will give you a Compliance Certificate,showing that the work complies with all
25YELLOW/GREEN240 V MAINS PLUGNNALMHTH2MOD1MOD2BLACKWHITEORANGEGREYPURPLEBROWNBLUEBLUEBLACKBROWNWHITEBLUEWBLKBRNBLACKBROWNREDREDWHITEREDNOCOMMONFUSEBL
Please read this manual before installing and using the heater.Safety warnings524To remove the heat exchangerPlease refer to manufacturer.To replace t
6238. If removed, the glass window must be put back onto the unit prior to operating the heater.9. Installation and repairs should be performed by a
Operating instructionsPlug the power cord into the wall socket and turn on the power to the heater (see figure 2). Alternatively, switch on the isola
821CleaningAll cleaning should be carried out when the heater is cold. Normally theheater should only need wiping with a lint-free damp cloth. Any s
920For minimum clearances refer figures 4 and 5.Note: Ensure that the combustion air opening under the heateris not obstructed. Installation in
Comments to this Manuals