Cannon 10455G Service Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14
GRIDDLE
A non-stick griddle is supplied for use over the two burners on the right hand side of the hob. The griddle is
made of cast iron and the surface is covered with a special nonstic k finish. To protect the non-stick coating
never use metal cooking utensils
as they may scratch the surface. Wooden or heat resistant plastic utensils
may be used. Do not use saucepans on the griddle plate.
UNDER NO CIRCUMSTANCES MUST THE GRIDDLE PLATE BE USED OVER ANY OTHER HOTPLATE
BURNERS.
USE OF THE GRIDDLE
The griddle may be used with either or both of the burners on, depending on the food being cooked. The
griddle can be positioned with the ridged portion at the front or at the rear.
1. Secure the griddle above the two simmer burners, on the right hand side of the hob, making sure that the
support feet are located correctly on the pan support fingers.
2. Press the ignition button and then p ush in and turn the control knob(s) of the burners anticlockwise to the large
flame symbol. Continue to press the ignition button until the spark lights the gas. Preheat the griddle plate for
approximately four minutes.
3. Place the food directly
on the griddle plate. However when cooking drier foods eg. drop scones the griddle
plate can be lightly greased.
4. The controls can be left at high for the sealing of foods or turned down to a lower heat setting depending on what
food is being coo
ked. NB. A gentle heat is all that is required for the majority of griddling. Once the griddle
plate is up to temperature it maintains the cooking temperature on a medium/low setting.
5. Cook the food for the required time, which will depend on the type of food being cooked.
6. To turn off, push in and turn the control knob(s) fully clockwise to the O position.
7. Allow the griddle plate to cool before cleaning.
In the event of the burner flames being accidentally extinguished, turn off the burner controls and do not
attempt to re-ignite the burners for at least 1 minute.
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments